mastering outboard gear Oberon 2A

mastering outboard gear Oberon 2AFeatures Aimed squarely at the mastering engineer, Oberon 2A boasts two bays of eight rack units which are angled towards the central listening position. The 'wrap around' geometry allows you to access the masses of 19" outboard gear you've collected over the years. Elevate your studio speakers on the angled platforms and finally get your mastering signal chain sorted. Studio Ergonomics The angled speakers and computer display shelf is set relatively

Features
Aimed squarely at the mastering engineer, Oberon 2A boasts two bays of eight rack units which are angled towards the central listening position. The 'wrap-around' geometry allows you to access the masses of 19" outboard gear you've collected over the years. Elevate your studio speakers on the angled platforms and finally get your mastering signal chain sorted.

Studio Ergonomics
The angled speakers and computer display shelf is set relatively low to the floor in order to minimize acoustic reflections and provide sufficient separation for your array of speakers to breath.

Cable Management
Is achieved by the provided large cable channel located at the rear of the central work area. Each end of the cable channel feeds into the left and right rack bays. 

In the rear of the racks, the supplied lacing bars are mounted between the rack strips, to which you can tie cables.

Cabling through holes allow for cable routing between every nook of the desk.

Available in black, white and natural grain finishes.