sublimation plant pot blanks Spring Flower Pot Earring Sublimation Blanks | ARA - Gloss Single

sublimation plant pot blanks Spring Flower Pot Earring Sublimation Blanks | ARA - Gloss SingleThis unisub sublimation blank was created solely for using with the image created by Alicia Ray Art which can be found HERE *DESIGN NOT INCLUDED* AND MUST BE PURCHASED SEPARATELY IF YOU DO NOT ORDER THE TRANSFER SET* **Please send Pioneer a message or email us (pioneersupplierandcreations@gmail. com) if you need help matching this design to our blank** Finished Size W 1. 18" H 1. 65" Template Print Size W 1. 28" H 1. 75" (Print Opposite Sides) Click

This unisub sublimation blank was created solely for using with the image created by Alicia Ray Art which can be found HERE

*DESIGN NOT INCLUDED* AND MUST BE PURCHASED SEPARATELY IF YOU DO NOT ORDER THE TRANSFER SET* 

**Please send Pioneer a message or email us ([email protected]) if you need help matching this design to our blank**

Finished Size | W 1.18"  H 1.65"

Template Print Size | W 1.28"  H 1.75" (Print Opposite Sides)

Click HERE to see all blanks for Alicia Ray Art

MDF Unisub - approx. 2.8mm thick  (MUST BE MIRRORED)

Acrylic Unisub - approx. 4.6mm thick (DO NOT MIRROR)

✔️ Gloss (clear film) Matte (blue film) Acrylic (clear film both sides)

✔️️  Sold as 1 pair (2 pcs) or in kits of 2 or 4 pair

✔️️ PNG Template download emailed upon order fulfillment 

✔️ Backside of single sided mdf blanks are unfinished and may have some burn marks around the edges due to the nature of being laser cut. 

✔️️ IMAGE MUST BE PURCHASED SEPARATELY TO COMPLETE PROJECT IF YOU DO NOT ORDER THE TRANSFER SET

PRESSING INSTRUCTIONS for Unisub MDF:

1. Remove all the clear or blue film from the substrate.
2. Remove residue, if any, with a soft damp cloth from unisub MDF.
3. Place your MDF substrate onto your transfer and secure with heat tape.
4. Press for 50-55 seconds @ 380 degrees medium pressure. (Time and temp may vary based on your heat press

PRESSING INSTRUCTIONS for Unisub Acrylic:

1. Remove the clear film from both sides of the substrate.
2. Place your acrylic substrate onto your transfer and secure (white side against transfer). I use 3m repositional spray so I do not end up with tape indentions on acrylic. 
3. Press for 120 seconds @ 355 degrees medium pressure. (Time and temp may vary based on your heat press)
4. Immediately remove and apply heavy even pressure on a smooth flat surface to cool so it will not warp. Make sure all surfaces are clean of grit (all will cause indents on substrate)
   

Join the Pioneer Supplier and Creations VIP on Facebook for new releases and sales!

Blank Sublimation Unisub Acrylic and MDF, Ready to Sublimate

47640241