fanatec csl pedal mods Fanatec CSL Haptic / Rumble/ Bass Shaker Mounts – Sim Race Mods

fanatec csl pedal mods Fanatec CSL Haptic / Rumble/ Bass Shaker Mounts – Sim Race ModsChoose your weapon! Mount all the popular feedback options to your CSL pedals All controlled with simhub on PC Mounts will fit Throttle Brake or Clutch, with or without loadcell and whether your pedal plates mount with a screw in the front or back Budget Friendly The classic xbox rumble motor we sell the controllers for these in kit form if youre feeling soldery, to be honest youre best off stretching to the next level of feedback Awesomeness Rating 5

Choose your weapon!
Mount all the popular feedback options to your CSL pedals
All controlled with simhub on PC
Mounts will fit Throttle Brake or Clutch, with or without loadcell and whether your pedal plates mount with a screw in the front or back

Budget Friendly
The classic xbox rumble motor- we sell the controllers for these in kit form if youre feeling soldery, to be honest youre best off stretching to the next level of feedback
Awesomeness Rating 5/10

Mid Budget
50mm transducers, or Dayton TT25's, similar price, similar feeling. used with a usb amp such as "nobsound". very easy to set up and gives all sorts of feedback at varying frequencies
Awesomeness Rating 7/10

'Take my money' Budget
Simagic Haptic motors, can run off a "nobsound" amp, or use the Simagic haptic control box, both have their positives and negatives, but this motor gives a good 'thump' effect to simulate ABS, but turn it too high and you might just lose use of your leg for a while
Awesomeness Rating 8/10 (+1 for looking so cool)

To Fit:
50mm Transducer-
* Remove Pedal Face
* Insert long screw into mount
* Attach mount to back of pedal with pedal face screws
* Screw Transducer onto the exposed M5 thread

Dayton TT25
* Remove Pedal face
* Replace pedal face and Secure small part of mount to pedal (The standard screws are T15 Torx so youll need this tool to remove them)
* Attach they Dyaton holder to the mount using the M6 screws supplied. Screw head will be facing out, nut will be visible once mounted
* Attach Dayton to mount using the 6 screws that came with your Dayton

Simagic
*Attach motor to mount, start with the screws in the tight corner, just start them loose until all 4 screws are threaded
*Tighten
* Remove Pedal Face
* Slide mount over pedal arm
* Attach pedal face


***Motors are not included, this is just the mounts to be able to attach them to your pedals***